How We Install a Floor in One Day
Good floors are 80 percent preparation. Here is exactly what happens from your first call to the moment you park on your new floor.
The Free Estimate
An estimator comes to your home, measures the space, and looks closely at your concrete. We check for moisture, existing sealers or paint, cracks, and any damage that needs repair. You will see color samples in person, ask all the questions you want, and get a written price before we leave.
Prefer to start remotely? Send a few photos and the dimensions of the space through our estimate form and we can give you a ballpark before we visit.
Step TwoInstall Day
Grinding. We diamond grind the full floor with industrial grinders connected to HEPA dust extraction. This removes the weak top layer, old sealers and surface stains, and leaves a profile the coating can grip.
Repairs. Cracks, pits and spalled areas are filled and ground flush. Control joints are handled so the floor can still move with the slab.
Base coat and flake. A pigmented base coat goes down and we broadcast decorative flake until the floor is fully covered. That full broadcast is what gives the floor its texture, depth and toughness.
Scrape and topcoat. Once the base is set, we scrape off loose flake, vacuum thoroughly, and apply the clear polyaspartic topcoat.
Step ThreeBack to Living
Foot traffic is fine in a few hours. Give it about 24 hours before you park, and a few days before dragging heavy equipment or setting rubber mats. We leave you with care instructions and your written warranty.
The Four Steps
Free Estimate
We measure, check moisture, look at every crack, and give you a written price on the spot. No pressure and no "today only" games.
Diamond Grind
Industrial diamond grinders open up the concrete so the coating bonds into it, not on top of it. Dust is captured by HEPA vacuums.
Repair & Base Coat
Cracks and spalls are filled. A pigmented base coat goes down and is fully broadcast with your choice of decorative flake.
Polyaspartic Topcoat
We scrape, vacuum, and seal with a clear polyaspartic topcoat. Walk on it in hours and park on it in about a day.
How It Compares
| Our Polyaspartic System | Typical Epoxy | DIY Kit | |
|---|---|---|---|
| Install time | One day | 2 to 4 days | A full weekend, plus cure time |
| Back in service | Walk in hours, park in about 24 hours | Park in 3 to 7 days | Park in about 7 days |
| Surface prep | Diamond grinding | Grinding or acid etch | Acid etch or degreaser |
| UV stability | Will not yellow in sunlight | Can amber or yellow | Often yellows |
| Hot tire pickup | Highly resistant | Can lift under hot tires | Common failure point |
| Installed by | Our trained crew | Varies | You |
Ready for a floor you're proud of?
Free on-site estimates across Dallas Fort Worth and North Texas.